Email:market@saintkingchina.com
 Tel:+86-574-86817275
 Fax:86-574-86817255
  WhatsApp/WeChat/Mobile/Linkedin:+86-13164998278
Ningbo SaintKing is a manufacturer of of printing high definition water transfer films since 2013.
How to operate the water temperature setting time for water transfer film processing?
You are here: Home » News » Water Transfer Printing » How to operate the water temperature setting time for water transfer film processing?

How to operate the water temperature setting time for water transfer film processing?

Author: Site Editor     Publish Time: 2021-04-26      Origin: Site

How to operate the water temperature setting time for water transfer film processing?

1:The water transfer film is processed to determine the appropriate water temperature, and the water surface is kept overflowing.

2.Keep the water surface free of activator residue and impurities.

3.Place the film and lay the film flat on the water surface at an appropriate angle (make sure the front and back of the film, with the printing layer facing up)

4.Set the dissolution time with the water temperature, the water temperature is generally not higher than 27-30 degrees, and the dissolution time is about 1 minute 30 seconds to 2 minutes.

5.Depending on the thickness of the printing ink, the time to spray the activator is judged. The thicker the ink layer, the activator can be sprayed in advance before the film is completely dissolved, so that the ink activation time will be prolonged, and the general operating conditions can dissolve for about 1 minute and 30 seconds. Spray the activator, wait for the film to become a mirror and expand flatly (5 seconds-1 second), then the film can be applied and transferred.

6.Before applying the film, it is necessary to choose the water angle according to the shape or texture of the processed material to facilitate the air discharge.

7.After the film is applied, it should not be picked up immediately. It should be shaken in water for 2-3 seconds to increase the time for asking directions to bite the processed object.

8.Activator spraying needs to be operated with a 1.2mm*4 hole spray gun and agitable pressure. The spraying distance is about 30cm. The amount of water in the tank needs to be overflowed and needs to be cleaned. After the flushing is completed, it needs to be air-dried and reconditioned by quality control. Into the baking oven.


Contact us
Address: No72. Moganshan Road, Beilun ,Ningbo, China
Tel:+86-574-86817275   Fax: 86-574-86817255
WhatsApp/WeChat/Mobile/Linkedin:+86-13780030634
Email:market@saintkingchina.com
Website:www.chinasaitking.com
Alibaba:appliqueleader.en.alibaba.com/

Share to

Copyright © Ningbo Saintking Decal Co., Ltd.